NanoAvionics、JSC

This 4-channel AIS receiver, Polaris, is designed by Nano Avionics partner Satlab. Polaris is a fully self-contained software defined radio receiv...

The SatCOM TP0 is a high quality FM repeater for small satellites designed by Nano Avionics partner LY3H. Pre-programmed and pre-configured prior ...

NanoAvionics GaAs (Triple Junction GaInP / GaInAs / Ge epitaxial construction) solar arrays are made from high performance triple junction space g...

The full-duplex low-power S-band transceiver is designed by Nano Avionics partner Satlab for microsatellite and nanosatellite TM and TC. The transc...

Designed for pico and nanosatellite applications by NanoAvionics partner IQ-Wireless, it implements high data rate satellite-to-ground communicatio...

The S-band transmitter is designed by Nano Avionics partner IQ-Wireless, enabling small satellite missions that require high data throughput at a ...

The NanoAvionics UHF antenna system consists of an RF splitter and four monopole antennas. RF splitters are an important element of a turnstile an...

The UHF radio utilizes a half-duplex architecture with a high-performance, low-power transceiver controlled by a dedicated ARM Cortex-M4 MCU. The ...

It can be ordered as a separate component or as an integrated 4-reaction wheel redundant 3-axis control system, enabling accurate pointing of small...

The system realizes approximately 80% of the cost of a significant restart of satellite operators. The propulsion system is designed to be modular ...

The NanoAvionics CubeSat Standard Structure was developed as a general-purpose modular microsatellite structure that complies with the CubeSat des...

Designed by Nano Avionics, the SatBus MTQ is a set of two (X-axis and Y-axis) magnetic torque rods and one air-core Z-axis magnetic torque coil, m...

The NanoAvionics EPS Maximum Power Point Tracking (MPPT) power adjustment and distribution unit is designed to meet a variety of customer requirem...

NanoAvionics is a microsatellite mission integrator focused on providing new generation satellite buses and propulsion systems for the satellite a...

A device used to measure the line-of-sight vector to a celestial body that can be seen by a sensor. These sensors keep a map of a particular segmen...

The payload controller is a dedicated subsystem for the interface between the payload and the Nano Avionics CubeSat bus. There are various interfa...

The NanoAvionics satellite bus MP42 hardware and software, as well as the mission operations infrastructure, are established on a baseline archite...

The SatBus 3C2 is a flight computer tuned for small satellites and is compliant with the CubeSat standard. This system reduces the burden on your ...

A microsatellite bus based on a modular and highly integrated design. This increases the amount of payload and saves the customer's development cos...